Non-destructive testing of welds. Ultrasonic testing. Techniques, testing levels, and assessmentWhat is this standard about? This international standard specifies techniques for the manual ultrasonic testing of fusion welded joints in metallic materials thicker than or equal to 8mm which exhibit low ultrasonic attenuation. The standards guidelines detail specific testing techniques for metals that show weakened ultrasonic levels at temperatures of up to 60C. Its mainly designed for full penetration weld joints where both the welded and parent

Owners upgrading an existing asset

2 Distribution of filament strain

BS EN 1076 is a European Standard which specifies performance requirements and test methods under prescribed laboratory conditions for the evaluation of pumped samplers used in conjunction with an air sampling pump and of procedures using these samplers for the determination of gases and vapours in workplace atmospheres

1) To maintain any compartmentation of buildings needed to limit the spread of fire and smoke

The series has been prepared under a mandate given to CEN by the European Commission and the European Free Trade Association

ISO 29463-4

it is anticipated that further development will result in greater precision in defining terms

Definitions from the Unified Modeling Language

Test laboratories of steel products

if the provisions of BS EN 12044 are different from those which are stated in type A or B standards

Tractors and machinery for agriculture and forestry — Serial control and communications data network — Part 1: General standard for mobile data communication

Contents of BS 5440-2: